Motion
Control Specialists
with
special interest in R/C model helicopter control
CSM Ltd, PO Box 101, Glossop
SK13 5ZW, England.
email: tech@csm-ltd.co.uk Tel: +44 (0)1457 854680
email: tech@csm-ltd.co.uk Tel: +44 (0)1457 854680
Size 34 x 34 x21mm
Weight 31g including on-board rechargeable battery
Regulated LiPo supplies provide a constant voltage supply to your RC system at low weight. However, they do run the risk of sudden regulator failure leaving you with no control and, with no servo power, defeating the receiver's fail-safe system. With IC models this means you can have the throttle stuck wherever it was when the regulator failed! ThrottleSafe protects against this eventuality by shutting the throttle servo using its on-board reserve battery should the regulator supply drop too low or fail completely.
- Throttle fail-safe even for total RC system power failure (e.g. regulator open circuit failure)
- In-flight low voltage warning by throttling back to idle for 1 second every 30 seconds.*
- LED voltage indicator*
- Fail-safe in case of throttle signal loss with timed hold-at-idle followed by engine cut for persistent signal loss *
- Latched supply fault and signal loss indicators.
- Shuts throttle on normal radio turn off - inhibits engine starting with radio off.
Download manual Download software
BEC failures can be very expensive. When faulty, BECs may place close to the full battery voltage onto the RC system burning out your receiver, servos and gyro - and leaving you with no control over the model! BECSafe protects against this as well as under-voltage and total power loss failures in BEC powered systems.
- Protects RC system from over-voltage should BEC fail short-circuit - switches RC gear to your reserve battery to maintain control.†
- Maintains RC supply by switching to your reserve battery should BEC voltage drop too low or fail completely.†
- Automatically checks BEC output before passing it to the RC system.
- Automatically sets over-voltage and under-voltage trip points to suit BEC output.
- BEC OK and BEC failure indicator LEDs
Current capacity: 10 amps. Low voltage loss (typically less than 0.1v with 5 amps load).
Download manual
Size 35 x 24 x 9mm
11g
RRP £14.95
All our helicopter products are distributed worldwide through RC Models Distribution Ltd, and should be available from your local model shop or mail order company. To find your nearest stockist see the RC Models shops page
phone +44 (0)1457 860001 or email sales@rcmodels.org
