CSM RevLocks

REVLOCK:
a quantum leap in engine control

NEW! REVLOCK 40

Advanced G-Sensitive Collective Management.

Now there is no need to compromise your set-up between high-g capability and ultimate climb and flight speeds. RL40 intelligently applies collective management to give you the best of both worlds.
Like its predecessor, the RL30, this governor will, when needed, limit the amount of collective pitch available to prevent excessive loss of head-speed in high-g manoeuvres. However, RL40 goes one stage further, and by incorporating an accelerometer is able to recognize low-g flight situations such as fast forward flight and vertical climbs where greater performance can be obtained by allowing more collective pitch to be employed even where this results in some loss of head speed.

It also greatly simplifies the set-up and installation by removing the need for careful pitch range adjustment.

REVLOCK 30

Takes helicopter governors to a new level with Collective Management, another innovative performance-enhancing idea from CSM.

RL30 has all the accuracy, ease of installation and flexibility for which RevLocks are renowned. But now, when you reach the limits of the power output of the engine, RL30 automatically modulates the maximum collective pitch available to prevent the engine becoming bogged down.

With RL30 your can use more collective pitch range than with a conventional governor. You get higher flight speeds and snappier transient high g manoeuvrability. In sustained high g and high cyclic situations RL30 almost imperceptibly regulates the maximum collective pitch to keep your engine in the power band leaving you to concentrate on the flying.

All our products are distributed worldwide through RC Models Distribution Ltd, and should be available from your local model shop or mail order company.
To find your nearest stockist see the RC Models shops page
phone (+44) 161 929 5955 or email sales@rcmodels.org

REVLOCK: a quantum leap in engine control

Get maximum power and maximum control with CSM's RevLock engine governors! RevLock locks your engine RPM to a pre-set speed for the smoothest hovering conditions, unrivalled rotor speed retention in aggressive 3-D flight, and maximum engine power and gyro gain. And because CSM RevLock is the only engine governor to use a digitally synthesised 'virtual engine' reference, it gives the most accurate RPM every flight - with no need for a tacho. Also recommended for beginners! RevLock reduces the need to alter throttle curves, and protects your equipment from over-revving. CSM's Linear Hall-Effect sensor works with the magnet fitted either way around, and ensures the simplest possible set-up. Available in four versions to suit all budgets and all flying styles: RL10 - simple governor, ........RL20 - governor/limiter RL30 - Collective management governor, ...RL40 G-sensitive Collective management Upgrade from RL30 to RL40 Why should I use an engine governor? - more info Using RevLock with a gasser or electric model.

NEW! REVLOCK 40 Advanced G-Sensitive Collective Management. Now there is no need to compromise your set-up between high-g capability and ultimate climb and flight speeds. RL40 intelligently applies collective management to give you the best of both worlds. Like its predecessor, the RL30, this governor will, when needed, limit the amount of collective pitch available to prevent excessive loss of head-speed in high-g manoeuvres. However, RL40 goes one stage further, and by incorporating an accelerometer is able to recognize low-g flight situations such as fast forward flight and vertical climbs where greater performance can be obtained by allowing more collective pitch to be employed even where this results in some loss of head speed. It also greatly simplifies the set-up and installation by removing the need for careful pitch range adjustment.
Main unit: Size 30 x 35 x 4 mm Weight 9g RRP £69.95 Accelerometer head: Size 18 x 26 x 4 mm Weight 2g	As with all RevLocks, RevLock 40:- - Protects your equipment from over-revving - Locks to a digitally synthesised reference: gives the greatest accuracy and fastest response - Maintains power and control in aerobatics - Ideal for beginners: easy to installl and helps with throttle curve setup - You’re in control: switch modes and alter speed and responsivity from your Tx. - Like RevLock 20 & 30, is adjustable via PC Interface: set parameters from home or your laptop, compatible with the CSM LPT and USB PC interfaces Supplied with sensor, magnet, accelerometer head, three stainless steel mounting brackets, four 300 mm leads, mounting foams, adhesive heat-shrink sleeving, pot adjuster. Requires a PC interface to access all features, and a mixer such as CycLock to be able to utilize the Collective Management on CCPM models, otherwise can be used as a normal governor. USB interface: £24.95............RevLock 40 + CycLock RRP £94.90 RevLock 40 manual RevLock 40 'At a Glance' card RevLock 40 PC software RevLock 40 PC instructions and tuning guide In German: RevLock 40 manual RevLock 40 'At a Glance' card RevLock 40 PC instructions and tuning guide Technical support

REVLOCK 30 Takes helicopter governors to a new level with Collective Management, another innovative performance-enhancing idea from CSM. RL30 has all the accuracy, ease of installation and flexibility for which RevLocks are renowned. But now, when you reach the limits of the power output of the engine, RL30 automatically modulates the maximum collective pitch available to prevent the engine becoming bogged down. With RL30 your can use more collective pitch range than with a conventional governor. You get higher flight speeds and snappier transient high g manoeuvrability. In sustained high g and high cyclic situations RL30 almost imperceptibly regulates the maximum collective pitch to keep your engine in the power band leaving you to concentrate on the flying.
As with all RevLocks, RevLock 30:- - Protects your equipment from over-revving - Locks to a digitally synthesised reference: gives the greatest accuracy and fastest response - Maintains power and control in aerobatics - Ideal for beginners: easy to installl and helps with throttle curve setup - You’re in control: switch modes and alter speed and responsivity from your Tx. - Like RevLock 20, is adjustable via PC Interface: set parameters from home or your laptop, compatible with the CSM LPT and USB PC interfaces Supplied with sensor, magnet, three stainless steel mounting brackets, three 300 mm leads, mounting foams, adhesive heat-shrink sleeving, pot adjuster. Requires a PC interface to access all features, and a mixer such as CycLock to be able to utilize the Collective Management on CCPM models, otherwise can be used as a normal governor. USB interface: £24.95............RevLock 30 + CycLock RRP £85.90 RevLock 30 manual RevLock 30 'At a Glance' card RevLock 30 software RevLock 30 PC instructions and tuning guide In German: RevLock 30 manual RevLock 30 'At a Glance' card RevLock 30 PC instructions and tuning guide Technical support
				Size 30 x 35 x 4 mm Weight 9g RRP £55.95

Upgrade from Revlock 30 to RevLock 40 To upgrade your RevLock 30 to RevLock 40 please send your RL30 main unit to CSM for re-programming, cost £25 - includes accelerometer head and return insured postage. For further deatils please contact tech@csm-ltd.co.uk

		RevLock RL20: PC interfaceable, with limiter option New improved performance: better anti-hunt capability Limiter and Governor modes: pre-set one mode to Limiter using the PC interface, then switch in flight Adjustable via PC Interface: adjust the minimum and maximum control point, Integral Gain, and manual-mode responsivity with a CSM PC interface
Size 25mm x 35mm x 4mm Weight 7g

RRP : £45.95 Also available: Stator Gator version for gasser engines, for use with Stator Gator sensor (available from www.statorgator.com): £39.95 PC interfaces: LPT £12.95 or USB £24.95 Come with all drivers and software required. RevLock manual (RL20) RevLock 20 'At a glance' card RL20 PC software RL20 PC instructions: page 1 page 2 In German: RevLock manual (RL20) RevLock 20 'At a glance' card RL20 PC instructions Technical Support

RevLock RL10 A basic governor, the cheapest on the market. - Pre-set two engine speeds - Fine-tune engine speed in flight from your transmitter - Visual RPM display - no need to buy a tacho - Adjustable responsivity - Safety features RevLock 10: RRP £35.95 Stator Gator version: discontinued RevLock manual (RL10) RevLock 10 'At a glance' setup card In German: RevLock manual (RL10) RevLock 10 'At a glance' setup card Technical Support
			Size 25mm x 35mm x 4mm Weight 7g

All our products are distributed worldwide through RC Models Distribution Ltd, and should be available from your local model shop or mail order company. To find your nearest stockist see the RC Models shops page phone (+44) 161 929 5955 or email sales@rcmodels.org