Get maximum power and maximum control with CSM's RevLock engine governor! RevLock locks your engine RPM to a pre-set speed for the smoothest hovering conditions, unrivalled rotor speed retention in aggressive 3-D flight, and maximum engine power and gyro gain.

And because CSM RevLock is the only engine governor to use a digitally synthesised 'virtual engine' reference, it gives the most accurate RPM every flight - with no need for a tacho.

Also recommended for beginners! RevLock reduces the need to alter throttle curves, and protects your equipment from over-revving. CSM's Linear Hall-Effect sensor works with the magnet fitted either way around, and ensures the simplest possible set-up.

Also available: Stator Gator version for gasser engines.
For use with Stator Gator sensor (available separately)

NEW RevLock RL20

New improved performance: better anti-hunt capability

Limiter and Governor modes: pre-set one mode to Limiter using the PC interface, then switch in flight

Adjustable via PC Interface: adjust the minimum and maximum control point, Integral Gain, and manual-mode responsivity with your existing CSM interface (also available separately, priced £12.95)

Find out more...

Size 25mm x 35mm x 4mm
Weight 7g

Full version: £54.95
Stator Gator version: £49.95

PC interface supplied with SL720 and SL560. Available separately at £12.95 (LPT) or £24.95 (USB).

RevLock RL10
As used by Duncan Osbourne in the 3D Masters 2005!

- Pre-set two engine speeds
- Fine-tune engine speed in flight from your transmitter
- Visual RPM display - no need to buy a tacho
- Adjustable responsivity
- Safety features

Find out more...

Full version: £44.95
Stator Gator version: £39.95

RevLock manual (RL10)
RevLock manual (RL20)
RevLock 10 'At a glance' setup card
RevLock 20 'At a glance' setup card
RL20 PC software
RL20 PC instructions: page 1 page 2
Technical Support